This brief presents a behavioral model structure and5a model-based phase-only predistortion method that are suitable for outphasing RF amplifiers. The predistortion method is based on a model of the amplifier with a constant gain factor and phase rotation for each outphasing signal, and a predistorter with phase rotation only. The method has been used for EDGE and wide-band code-division multiple-access (WCDMA) signals applied to a Class-D outphasing RF amplifier with an on-chip transformer used for power combining in 90-nm CMOS. The measured peak power at 2 GHz was +10.3 dBm with a drain efficiency and power-added efficiency of 39% and 33%, respectively. For an EDGE 8 phase-shift-keying (8-PSK) signal with a phase error of 3 degrees between the two input outphasing signals, the measured power at 400 kHz offset was −65.9 dB with predistortion, compared with −53.5 dB without predistortion. For a WCDMA signal with the same phase error between the input signals, the measured adjacent channel leakage ratio at 5-MHz offset was -50.2 dBc with predistortion, compared with -38.0 without predistortion.