This thesis presents the design, optimization, and validation of a custom RadarPrinted Circuit Board (PCB) based on Texas Instruments' IWRL6432AOP 60 GHz mmWave FMCW sensor, targeting integration into space constrained and power-limited access control products such as door intercoms.The PCB was designed as a 6-layer HDI stackup using halogen-free FR-4 material (IPC-4101E/128) with blind and buried microvias, and interfaces to the host system via a 14-pin 0.5 mm-pitch FPC connector and SPI bus. DC drop simulations (Siemens HyperLynx) confirmed 10.6% and 33.3% reductions in voltage drop on the 1.8 V and 1.2 V power rails, respectively, compared to the reference design.Laboratory measurements demonstrated a 60% reduction in transient power peaks (from 1408 mW to 557–609 mW) and 25–30% lower average power consumption under the low-power chirp configuration compared to the high performance mode. The final PCB footprint was reduced to 15 × 25 mm, well within the mechanical constraints of the target intercom product. Real time radar operation was verified through an end-to-end SPI–Ethernet–Python GUI communication chain, confirming functional presence detection capability.The results validate that optimized bulk capacitance placement combined with improved PCB power routing effectively suppresses transient current spikes without requiring additional active power control circuits, establishing a viable hardware platform for next-generation radar-based access control systems