Ce microalloying and strain rate effects on mechanical anisotropy and the Portevin-Le Chatelier phenomenon in rapidly solidified thin-strip cast AA5182 Al-Mg alloyShow others and affiliations
2026 (English)In: Materials Science & Engineering: A, ISSN 0921-5093, E-ISSN 1873-4936, Vol. 976, article id 151048Article in journal (Refereed) Published
Abstract [en]
This study examines the effects of minor Ce microalloying (similar to 0.15 wt%) and strain rate (10(-3)-10(-1) s(-1)) on the microstructure, solidification microtexture, plastic anisotropy, and deformation behavior of rapidly solidified thin-strip (TS) cast AA5182 Al-Mg alloy. Microstructural characterization reveals that Ce microalloying modifies the solidification pathway by suppressing the formation of Mg/Si-rich eutectic intermetallics (e.g., beta-Al3Mg2) and promoting the emergence of Ce-rich compounds, consistent with enhanced non-equilibrium solute redistribution. Although the TS casting produces fine semi-equiaxed grains in both alloys, Ce subtly intensifies preferred crystallographic orientations by strengthening the S, Cu, and Q texture components while reducing the fraction of random orientations. Tensile testing at 0 degrees, 45 degrees, and 90 degrees relative to the casting direction shows that Ce microalloying decreases the yield strength through an effectively negative strain-rate sensitivity; however, it enhances the ultimate tensile strength and elongation at 0 degrees and 90 degrees, primarily due to improved strain-hardening capacity and more slip activity. Anisotropy increases with strain rate in both alloys, with Ce microalloying further elevating planar anisotropy (Delta r: 0.09 -> 0.16 vs. 0.12 -> 0.19) and in-plane anisotropy (IPA: 2.65%-> 6.99% vs. 3.29%-> 7.38%), indicating stronger texture-induced directional dependence. Both alloys exhibit strain-rate-dependent Portevin-Le Chatelier (PLC) behavior, transitioning from mixed Type-A + B serrations to predominantly Type-A at higher strain rates. Ce microalloying reduces the stress-drop amplitudes by up to 50% and increases the critical strain (epsilon(c)) for serration onset by 7-22%, reflecting enhanced flow stability. Fractography confirms fully ductile fracture in all samples, with Ce microalloying inducing finer and more uniformly distributed dimples. Hence, while Ce microalloying improves ductility and stabilizes plastic flow, it concurrently amplifies texture-driven plastic anisotropy in TS cast AA5182.
Place, publisher, year, edition, pages
Elsevier , 2026. Vol. 976, article id 151048
Keywords [en]
AA5182 Al-Mg alloy, Thin strip casting, Microalloying, Rare earth element (REE), Strain rate, Anisotropy, Portevin-Le Chatelier (PLC)
National Category
Materials Engineering
Identifiers
URN: urn:nbn:se:hig:diva-51124DOI: 10.1016/j.msea.2026.151048ISI: 001874992000001Scopus ID: 2-s2.0-105050603493OAI: oai:DiVA.org:hig-51124DiVA, id: diva2:2105061
2026-09-252026-09-252026-09-28Bibliographically approved